Apparently MotionEye is capable of sending MJPEG streams, so it's just a question of finding the right HTTP request that MotionEye understands for obtaining this stream. I believe the setup would be as follows:
- Under Preferences -> Cameras -> Device, create a new network device - Set the Profile to Manual - Set the Format to HTTP - Enter the username/password as set in MotionEye - Leave the Request blank - If there is a particular port shown in MotionEye for video streaming, enter that as the HTTP port
Comments
- Under Preferences -> Cameras -> Device, create a new network device
- Set the Profile to Manual
- Set the Format to HTTP
- Enter the username/password as set in MotionEye
- Leave the Request blank
- If there is a particular port shown in MotionEye for video streaming, enter that as the HTTP port
Does this work?
+1 for this thread. I successfully added my Raspberry Pi camera to Security Spy using this method.