Switch all cameras to a specified setting
  • When I leave my home unoccupied, I use Indigo home control to switch all sensors to a state of 'home unoccupied'. I would like to extend this to set all my cameras to an 'unoccupied' configuration (all recording motion etc.) and on the house becoming occupied to switch all the cameras to a different setting. Is this possible, ideally via Indigo but directly within SecuritySpy would be fine? I want to avoid having to manually change each camera every time I leave the house unoccupied.
  • This is possible using some simple AppleScripts, as follows:

    tell application "SecuritySpy"
        arm mode MotionCapture
    end tell

    tell application "SecuritySpy"
        disarm mode MotionCapture
    end tell

    The three modes are ContinuousCapture, MotionCapture and Actions, and you can also specify All to arm/disarm all modes.

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!